European spine journal : official publication of the European Spine Society, the European Spinal Deformity Society, and the European Section of the Cervical Spine Research Society
-
The low back pain of professional drivers could be linked to excessive lumbar load. This study aims at developing a musculoskeletal model to study the lumbar spinal loads and lumbar muscle forces of the human body in driving posture, so as to contribute to a better understanding of low back pain and to improve the design of vehicle seats. ⋯ There are two findings: (i) the lumbar spinal loads at the L3-L4, L4-L5 and L5-S1, and lumbar muscle forces decreased obviously with the 4 cm lumbar support, while the seat cushion inclination angle was set to 10°. (ii) The recommended backrest inclination angles are 29° to 33° with a 10° seat cushion to the horizontal, which can keep a low level of the lumbar spinal loads and lumbar muscle forces. This study could be used to explain the association between drivers' sitting posture and the lumbar load change, and provide a reference for the prevention of low back pain.
-
Odontoidectomy for ventral compressive pathology may result in O-C1 and/or C1-2 instability. Same-stage endonasal C1-2 spinal fusion has been advocated to eliminate risks associated with separate-stage posterior approaches. While endonasal methods for C1 instrumentation and C1-2 trans-articular stabilization exist, no hypothetical construct for endonasal occipital instrumentation has been validated. We provide an anatomic description of anterior occipital condyle (AOC) screw endonasal placement as proof-of-concept for endonasal craniocervical stabilization. ⋯ Endonasal placement of AOC screws is feasible using a 0° driver. Our measurements provide useful parameters to guide optimal placement. Given proximity of hypoglossal canal and jugular bulb, neuronavigation is recommended. Biomechanical studies will ultimately be necessary to evaluate the strength of AOC screws with plate-screw constructs utilizing endonasal C1 lateral mass or C1-2 trans-articular screws as inferior fixation points.
-
The etiology of neck/shoulder pain is complex. Our purpose was to investigate if respiratory disorders are risk factors for troublesome neck/shoulder pain in people with no or occasional neck/shoulder pain. ⋯ Our findings indicate that those with no or occasional neck/shoulder pain and reporting to suffer from asthma or COPD increase the risk for troublesome neck/shoulder pain over time. This highlights the importance of taking a multi-morbidity perspective into consideration in health care. Future longitudinal studies are needed to confirm our findings.
-
The goal of this study was to provide recent data on incidence of spinal cord injuries (SCI) in Germany. ⋯ This study closes a long-lasting gap in epidemiological data regarding SCI in Germany, specifically by updating the incidence rates. We found that incidence depends on age, gender and type of lesion. We also provide some new angles for future research, especially considering the relative reduction in complete injuries among the elderly.
-
Observational Study
Spinopelvic fusion surgery from lower thoracic spine to pelvis increased hip joint moment-motion analysis.
Spinal fusion surgery is often performed with pelvic fixation to prevent distal junctional kyphosis. The inclusion of spinopelvic fixation has been reported to induce progression of hip joint arthropathy in a radiographic follow-up study. However, its biomechanical mechanism has not yet been elucidated. This study aimed to compare the changes in hip joint moment before and after spinal fusion surgery. ⋯ This study revealed that hip joint flexion-extension and abduction-adduction moments increased after spinopelvic fixation surgery in the postures of standing, walking, and climbing stairs. The mechanism was considered to be adjacent joint disease after spinopelvic fusion surgery including sacroiliac joint fixation.