European spine journal : official publication of the European Spine Society, the European Spinal Deformity Society, and the European Section of the Cervical Spine Research Society
-
Spinal fusion is a widely and successfully performed strategy for the treatment of spinal deformities and degenerative diseases. The general approach has been to stabilize the spine with implants so that a solid bony fusion between the vertebrae can develop. However, new implant designs have emerged that aim at preservation or restoration of the motion of the spinal segment. In addition to static, load sharing principles, these designs also require a profound knowledge of kinematic and dynamic properties to properly characterise the in vivo performance of the implants. ⋯ The results agree with published data obtained from cadaver studies with and without axial preload. Intraoperatively acquired data with this method may serve as an input for mathematical models and contribute to the development of new implants and treatment strategies.
-
The last few decades have witnessed a paradigm shift in the assessment of outcome in spine surgery, with patient-centred questionnaires superseding traditional surgeon-based assessments. The assessment of complications after surgery and their impact on the patient has not enjoyed this same enlightened approach. This study sought to quantify the incidence and bothersomeness of patient-rated complications 1 year after surgery. ⋯ Most complications reported by the patient are perceived to be at least moderately bothersome and hence are not inconsequential. Complications and their severity should be assessed from both the patient's and the surgeon's perspectives--not least to better understand the reasons for poor outcome and dissatisfaction with treatment.
-
The measurement of transverse pedicle width is still recommended for selecting a screw diameter despite being weakly correlated with the minimum pedicle diameter, except in the upper lumbar spine. The purpose of this study was to reveal the difference between the minimum pedicle diameter and conventional transverse or sagittal pedicle width in degenerative lumbar spines. ⋯ The MPD was significantly smaller than the TPW and SPW at L3, L4, and L5. The actual measurements of the TPW were not appropriate for use as a direct index for the optimal pedicle screw diameter at these levels. Surgeons should be careful in determining pedicle screw diameter based on plain CT scans especially in the lower lumbar spine.
-
The purpose of the study was to report radiological outcomes after total disc replacement (TDR) in the cervical spine through a 24 months follow-up (FU) prospective study with a special focus on sagittal alignment and kinematics at instrumented and adjacent levels. ⋯ Through this prospective study, we observed that cervical lordosis consistently increased after TDR. In addition, although ball-and-socket arthroplasty did not fully restore native segmental kinematics with significant reduction of motion in FE and consistent cranial shift of the COR, no significant changes in terms of ROM and CORs were observed at adjacent levels.