• Yoshiaki Ide, Suresh Nayar, Heather Logan, Brendan Gallagher, and Johan Wolfaardt.
• Department of Developmental and Regenerative Dentistry, The Nippon Dental University School of Life Dentistry at Tokyo, 1-9-20 Fujimi, Chiyoda-ku, Tokyo, 102-8159, Japan. ideaki@tky.ndu.ac.jp.
• Odontology. 2017 Jan 1; 105 (1): 108-115.

AbstractThe influence of the acuteness of the model angle and the direction of printing was investigated on different three-dimensional (3D) printers to understand the fidelity of 3D printing. A Polyjet printer and two fused deposition modeling printers were used in the present study. Computer-aided design (CAD) models were designed in the form of a triangular prism with a height of 15 mm and with varying angles of 60°, 45°, 30°, 20°, 10°, and 5°. From the CAD designs, additive manufacturing (AM) models were printed in three different directions by each of the three printers. To investigate the global fidelity of the 3D printers, the height and surface outlines of the AM model cross sections were measured. The fidelity of the AM models with increasingly acute angles was not accurately reproduced when 3D printed, and the surface outlines of the AM model cross sections were different in each direction of printing for each device. Printing technology and printing direction need to be considered if accurate reproduction of acute angles in fine AM structures in medical models is a necessity.

20 keywords...

hide…